Torsion Sway Bar Rebuild

From: $0.00

These are the rebuild parts for the Carli Torsion Sway Bar, past and present!

If you have any questions about the rebuild that this page doesn’t answer, shoot an email to and we’ll be happy to assist you!

SKU: Torsion Sway Bar Rebuild Category:


Installation Instructions for 2003-12

Installation Instructions for 2014+

To rebuild your Carli Torsion Sway bar, it’s as simple as removing and replacing components. We do not sell individual heim joints, rather complete assemblies as, if one heim is worn, the others aren’t far behind. The original Carli TSB came with 1/2″ heims with pre-installed studs, these have been superseded by the links offered above boasting 5/8″ FK Race Heims, Grade 5 All Thread (grade 8 is too brittle for the load these see), Jam nuts and 1/2″ Grade 8 hardware. These links will fit ALL Carli Ram Torsion Sway Bars, past and present.

The Bushing kit is a rare sale as we just don’t see these go out but many elect to replace them when tearing down and rebuilding to reset their life, necessary or not.

The Stainless Washers are an upgrade for those running the fender washers – they’re just plain sexy. Over the years, we’ve offered both 5/16″ and 3/8″ hardware, be sure you measure your hardware prior to ordering the washers as the Internal diameter is machined for a perfect fit.


Go to Top